Product Core Brief
- Model: 573-935-202C
- Brand: VIBRO-METER
- Series: VM600 family — to be confirmed from label
- Core Function: Likely a VM600 monitoring, I/O, or processing module for rotating-equipment protection.
- Product Type: VM600 rack module / monitoring card
- Key Specs: Pending datasheet | Pending channel count | Pending supply voltage
- Condition: New original / new surplus — verify before dispatch
Product Introduction
The VIBRO-METER 573-935-202C is listed as a VM600-series module, but its exact function must be confirmed from the nameplate. It may be a monitoring card, I/O companion, or processing module used inside a VM600 rack.
Do not assume channel count, sensor type, relay mapping, or firmware version. Treat this unit as a candidate spare and match it against the installed rack, paired cards, and OEM documentation before installation.
Key Technical Specifications
- Part number: 573-935-202C
- Manufacturer: VIBRO-METER
- Product family: VM600 system module — verify
- Module type: Pending datasheet
- Channel configuration: Pending datasheet
- Input type: Pending datasheet
- Output type: Pending datasheet
- Supply voltage: Pending datasheet
- Communication / backplane: VM600 internal bus — confirm
- Firmware / hardware revision: Verify on label
- Operating temperature: Pending datasheet
- Mounting: VM600 19-inch rack plug-in module — confirm
Quality Control Process (Pending Verification)
- Nameplate verification: Confirm 573-935-202C, hardware revision, serial number, and firmware.
- Connector inspection: Check front connectors, backplane pins, and mounting tabs for damage.
- Insulation and continuity check: Test for shorts, open circuits, and connector pin integrity.
- Functional test: Only perform if the correct VM600 rack, paired card, and test procedure are available.
- Packing: Use anti-static bag, edge protection, and rigid carton for shipment.
Replacement Pitfall Guide
❗ Do not substitute by partial part number. The “573-935-202C” suffix may differ from other VM600 cards in I/O mapping or firmware.
❗ Do not assume it pairs with any VM600 rack. Compatibility depends on the ABE series, backplane revision, and paired processing card.
❗ Verify supply voltage and signal levels before energizing. Wrong power or sensor excitation can damage the module.
❗ Record firmware and configuration parameters before removal. Swapping without configuration backup can cause alarm mismatches.
Keep these in mind and you’ll cut 90% of rework time.
Compatibility Matrix & Benchmarks
| Original Model | Replacement / Successor Model | Compatibility Level | Migration Notes |
|---|---|---|---|
| VIBRO-METER 573-935-202C | Same part number, matching revision | Pending verification | Match hardware/firmware revision |
| VIBRO-METER 573-935-202C | VM600 equivalent module | Unverified | Confirm exact module type first |
| VIBRO-METER 573-935-202C | Newer VM600 card | Pending OEM confirmation | Check Vibro-Meter/Parker Meggitt documentation |
Benchmarks: Pending datasheet. Typical VM600 module comparisons include channel count, sensor input type, relay/4-20 mA outputs, scan rate, and backplane compatibility, but none should be published here without official confirmation.
