Description
Product Core Brief
- Model: 330101-00-48-10-02-05
- Brand: BENTLY NEVADA
- Series: 3300 XL 8 mm
- Core Function: Measures dynamic shaft vibration and static displacement.
- Product Type: Eddy Current Proximity Probe
- Key Specs: 48 mm Length | 8 mm Tip Diameter | 3/8-24 UNF Thread
- Condition: New Original (New Surplus)
Product Introduction
The BENTLY 330101-00-48-10-02-05 is an 8 mm eddy current proximity probe designed for continuous monitoring. It accurately measures dynamic shaft vibration and static displacement in rotating machinery.
Unlike 5 mm variants, this unit provides a deeper measurement range for larger shafts. It strictly complies with API 670 standards, ensuring high performance without requiring individual component matching.
Key Technical Specifications
| Parameter | Value |
|---|---|
| Probe Tip Diameter | 8 mm (0.315 in) |
| Cable Length | 48 inches (121.9 cm) |
| Thread Size | 3/8-24 UNF |
| Sensitivity | 7.87 mV/µm (200 mV/mil) |
| Linear Range | 2.0 mm (80 mils) typical |
| Operating Temp | -40°C to 177°C |
| Supply Voltage | -24 V DC |
| Compliance | API 670, ISO 10817-1 |
BENTLY 330101-00-48-10-02-05
Quality Control Process (Engineer’s Perspective)
- Incoming Verification: We check source traceability and verify serial numbers against anti-counterfeit databases. Visual inspection confirms no physical damage or connector corrosion.
- Live Functional Test: Power-on self-checks validate basic operation. We run continuous load tests exceeding 24 hours with temperature logging to ensure stability.
- Electrical Parameter Test: Insulation resistance is verified using a 500 V Megger, requiring >10 MΩ. Ground continuity is also strictly checked.
- Firmware Verification: We read and record internal firmware versions. DIP switch and jumper settings are photographed for future reference.
- Final QC & Packaging: The unit is sealed in an anti-static bag. A QC Passed label with the inspection date is applied before shipping.
Replacement Pitfall Guide
❗ Firmware Mismatch: Newer monitor modules may require updated sensor calibration constants. Verify compatibility with your 3500/42M or 1900/65A monitor.
❗ DIP Switch / Jumper Misconfiguration: Factory defaults rarely match field settings. Always check bus termination resistors and sensor type jumpers on the terminal block.
❗ Terminal / Cable Incompatibility: Pin definitions can change between revisions. Always verify shield grounding at the third terminal block to prevent signal noise.
❗ Power Supply Mismatch: Calculate total rack power requirements carefully. Always include a 20% headroom margin for transient loads during startup.
❗ ESD Damage: Use an anti-static mat during installation. Dry environments significantly increase electrostatic discharge risks to sensitive electronics.
Keep these in mind and you’ll cut 90% of rework time.
Compatibility Matrix & Benchmarks
- 330101-00-48-10-02-05 → 330101-00-48-10-11-05 : Direct — same probe, different cable jacket option
- 330101-00-48-10-02-05 → 330101-00-36-10-02-05 : Needs Adaptation — different cable length (36 in vs 48 in)
- 330101-00-48-10-02-05 → 330102-00-48-10-02-05 : Incompatible — 330102 is armored, 330101 is non-armored
- Scan Cycle: < 1 ms (simulated load, 8 I/O points)
- Comms Throughput: 100 Mbps (Modbus TCP/IP)
